One of the most common errors would be the 0xc18a0206 error. Users are facing this error, so here's a quick guide for you. Read the article to fix the problem. In this case, you need additional help; you'll get it sorted very quickly, and then you can contact HP printer support!
First of all, what could be an HP 0xc18a0206 printer error?
HP Printer Error 0xc18a0206 illustrates the ink system failure. The error is also revealed from the printer's control panel.
What are the explanations for this error?
All of this HP printer is not installed correctly.
Printer cartridges without message.
The print cartridge may be damaged and not inserted correctly.
How to solve the problem?
Option 1: Use genuine HP ink cartridges.
Option 2: printer stand
Sometimes stressing over the printer as well as taking ink cartridges can fix the problem.
Turn on the printer.
Please be patient with the printer idle and silent until you continue.
Now disconnect the USB cable from the back of the printer.
When the printer has a wireless or network connection, set up the printer on the system or a wireless connection.
Remove ink cartridges from the printer today.
Now that the entire printer is turned on, unplug the power cord from the wall outlet and the back of the printer.
Wait at least 60 minutes.
Then plug the power cord back into the wall outlet.
Remember that the HP printer recommends plugging the printer power cable directly into a wall outlet.
Reconnect the power cord to the back of the printer.
Turn on the printer, if it does not turn on automatically.
The printer can go to the end using the warm-up period.
The printer lights might blink and the carriage might also be working.
Please be patient until the warm-up phase has been completed and the printer has been turned off and the printer is quiet before continuing.
Reinsert the print cartridges, and then close the print cartridge slot
If a message appears to print a calibration page, you must do exactly the same.
If the USB cable was disconnected by mistake, reconnect it at the back of the printer.
Now finally try to publish.
Step 1: Choose # and * at exactly the same time
Step 2: Choose 1, 2, 3 and you should see "Service R0632M"
Step 3: Select> and the "data menu" will appear
Step 4: Select> and you should see "setup menu"
Step 5: Select OK to display "standing hardware failure"
Step 6: Select OK "standing failure: apparent". Press OK to clear
Step 7: Select CANCEL
Step 8: Turn off the printer, unplug the power cord for two minutes, then plug it back in and turn the printer back on.
Please contact me. HP printer customer support when the problem is resolved.